Solomon Islands solar Water Pumping System

What is a solar water pump?

A solar water pump theoretically consists of three key components: a pump control system that may be just an on-off switch or may be a more complex electronic unit, a motor and the pump; however, in practice they are considered as one unit and generally called the “water pump” or in this guideline the “solar water pump”.

What does a solar water pump manufacturer/supplier do?

solar water pump manufacture/supplier will have tables or computer software which specify the flow from the solar water pumping system for various heads and solar irradiation. The “solar water pump designer” shall be capable of: Using the manufacturers data sheets or software to select the most appropriate solar water pumping system.

Where is a solar water pump located?

In these systems the solar water pump is located within the borehole or well. These pumps are generally available for 100 mm (4 inch) and 150 mm (6 inch) boreholes. The solar array is typically located near the top of the borehole/well and the water is generally pumped to a storage tank. The pump controller is typically located at the solar array.

What are the components of a solar water pumping system?

A solar water pumping system consists of three major components: the solar array, pump controller and electric water pump (motor and pump) as shown in Figure 1. Note: Motor and pump are typically directly connected by one shaft and viewed as one unit, however occasionally belts or gears may be used to interconnect the two shafts.